Building a NASA, SCCA, World Racing League, American Endurance Racing, Chumpcar, LeMons, or other race car? Save a ton of time during the build by using our pre cut parts.
 
Aluminium Race Seat mounting brackets - Race seat mounting is NEVER easy, and rarely a quick job. There are some very good seat mounts on the market these days, but many times, they still leave much to be desired. Many of you could just as easily make your own seat mount but aluminum seats sometimes prove difficult to mount especially at the front of the seats.
 
Use our weldable steel side mounts to make your own mounting system using square or round steel tubing. Our mounts are cut from 1/8" steel with slotted adjustments for the front side mounting holes which mount on the side of the seat. Brackets are available with or without rear holes so that you can place the holes where you need them! 1.5" Spreader washers are also available to spread the loads on the bolts. 
 
It'll still take way longer than you think to mount your seat BUT you will get the seat where you want it, and not have to hack up that $100+ seat mount that doesn't even fit to make it work.
 
Price is for 2 pieces.
 
Pictured is a Kirkey seat install in a Mazda Miata
 
These parts have been developed during various project builds at Izzy's. The parts were developed and tweaked for best final fitment on in house projects.
 
Unless noted, parts are shipped flat. When applicable, parts will have pre cut bend lines that are easily formed with a good vise and a 1 lb hammer or press brake. Simply prep the weld areas to bare clean metal, hammer form (or use a press brake) and weld up the cut lines once installation is complete. These are NOT bolt on parts. They will require some fabrication skills and tools to install.
 
Some trimming of edges may be necessary due to production line variances or prior chassis damage/repair.
 
Offroad use only. No warrenty expressed or implied. Racing is dangerous.